| Free Shipping to the Lower 48 States on Orders Over $95 |
The IP-400 is a 2000W amplifier built for heavy DJ/KJ use. There are no karaoke features built into this amplifier. With less parts, there is less introduction of signal or electronic noise. The IP-400 was built to deliver high quality, signal/noise free power to your most demanding speakers.
To channel the power correctly and noise free to the speakers, SPEAKON connectors are to be used. SPEAKON cables are shielded cables which prevent any electrical shock when attaching to non-shielded connections. This helps extend the life of all your equipment while providing noise free sound.
The IP-400 offers top power, superior performance and full professional operating features of a roadworthy compact chassis. It's perfect for even the most demanding sound reinforcement installation and touring applications.
Specifications:
| IP-400 | |
| Output Power | 1000W x2 (Peak) |
| Frequency Response (Half PWR) | 15hZ - 25KHz (+0/-1dB) |
| THD + Noise @ 1KHz (Full PWR) | <0.003% |
| IMD 60Hz & 7KHz; 4:1 | <0.038% |
| Signal To Noise Ratio | >102dB |
| Slew Rate | 40V/uS |
| Damping Factor | Selectable ( 0.77V / 1.0V / 1.44V ) |
| Input Sensitivity | 10k ohm balanced to ground |
| Input Impedance | Female XLR-3 & 6.35mm TRS Jack |
| Input Connectors | 2x XLR balanced Socket Unbalanced TRS 6.3MM Socket |
| Output Circuit Type | Class AB |
| Output Connectors | 4 Pole SPEAKON & Binding post |
| Protection | Full short-circuit, open-circuit, thermal, soft-start, DC voltage, Sub/Ultrasonic and RF |
| Led Indicators | Bridge, Parallel, Power, Signal, Clip, Protect |
| Panel Controls |
FRONT: 2 input attenuators REAR: Ground Lift, mode selection, compressor |
| Cooling | Rear Exhaustion via 2 variable-speed fans |
| Power Supply Voltage | 110V AC/50Hz |
| Power Supply Fuse | 15A @ 250 |
| Dimension: mm | 482 x 440 x132 |
